MakerBeamXL will replace the black anodised OpenBeam Kossel longer lengths (750mm, 360mm) once these are out stock. The clear anodised version and the shorter lengths (600mm and 240mm) will not be replaced.
Due to disappointing sales we made the decision to stop selling the shorter lengths that are meant for building a Kossel printer. The 600mm OpenBeam black (100685 – already sold out) and clear (100832) anodised and the OpenBeam 240mm black (100641) and clear anodised (100809) are end of line.
For the longer lengths (750mm and 360mm) we made the decision to offer these lengths in MakerBeamXL black anodised. These MakerBeamXL Kossel lenghts will only be available in small numbers. The MakerBeamXL Kossel lengths will be put online once we are out of stock for the OpenBeam black (100696, 100674) and clear anodised (101563, 101552).
Sensornet (.nl/english) is specialised in accurate, long-term measurement of environmental noise vibrations, air pollution and other environmental parameters. In order to calibrate their vibration sensor they needed a test setup. They wanted to test the response of the vibration sensor before it was used outdoors. First they looked into using a laboratory stand. This idea was rejected since the specialised equipment is rather expensive for just a simple test setup. Then they came across MakerBeam.
MakerBeamXL was thought to be the best option to use to carry the weight of their equipment and the lengths needed. Below you can see some pictures they sent us of their test setup in the office. The laser measurement device (in yellow) is used to calibrate the vibration sensor. The sensor is just above the metal tube. The metal tube is the vibration generator.
Peter made a Fischer Technik Unimog U400 strengthened with OpenBeam. Below you can see some pictures of Peter’s creation. On the blog of the Fischer Technik community you find more pictures and more info.
We share an office space with our colleagues from Wandy. One of them has two laptops but when in the office he wants to enjoy big screens. He wanted to place these screens higher than the added normal stands could provide. To optimise his workstation he turned to OpenBeam and created one computerstand to hold the two flatscreens. Here are some pictures.
A great project: a Liebherr crane made of Fischer Technik with OpenBeam used as reinforcement.
Peter Damen makes great items with Fischer Technik. Since he has known OpenBeam he uses OpenBeam to reinforce his projects. With this Liebherr crane he did the same. You can see where he used OpenBeam in these pictures below.
Clear OpenBeam for the longer lengths in the crane itself and pieces of black OpenBeam in the base.
You can read more about it and see more pictures on the fischer technik community website. Here is a link to Peter his project listed there.