3D printing and MakerBeam

In the previous post the Light Box was shown. The feet on the light box were different from the feet we sell. It turns out that Stefan made the feet himself.

Light Box

Stefan sent us the pictures of his Light Box (link to post webshop blog). The feet on the light box were different from the feet we sell. Stefan had actually designed and 3D printed new feet himself. The feet are a bit wider and higher. He needed more space from the bottom to fit the planned additional lighting. The extra is light is set to be mounted outside the box to shine into the cube from the bottom upward. See pictures of the special designed feet below.

Feet of Light Box in detail

He also made a photo cube which should rotate (driven by a small motor). Therefore he also created a special holder. See the first picture of the prototype below as well.

Cube holder

Stefan is planning to be present at the Maker Faire in Vienna. He wants to show all his work and all MakerBeam parts at this faire. The Maker Faire in Vienna (Austria) is scheduld for May 5 and 6. Here is a link to the Maker Faire Vienna website.

Test setup vibration sensor with MakerBeamXL

Sensornet (.nl/english) is specialised in accurate, long-term measurement of environmental noise vibrations, air pollution and other environmental parameters. In order to calibrate their vibration sensor they needed a test setup. They wanted to test the response of the vibration sensor before it was used outdoors. First they looked into using a laboratory stand. This idea was rejected since the specialised equipment is rather expensive for just a simple test setup. Then they came across MakerBeam.

MakerBeamXL was thought to be the best option to use to carry the weight of their equipment and the lengths needed. Below you can see some pictures they sent us of their test setup in the office. The laser measurement device (in yellow) is used to calibrate the vibration sensor. The sensor is just above the metal tube. The metal tube is the vibration generator.

Team MakerBeam



Products (almost) out of stock

Several products are (almost) out of stock: MakerBeam black anodised kits, MakerBeamXL black anodised kits, 600mm black anodised, 300mm black anodised etc.
Therefore we are also (almost) out of stock for our kits. Black anodised beams (MakerBeamXL or MakerBeam) have lowest stock levels.

We are expecting a new batch of beams coming in this July.  Around July 20th 2017 we will be fully stocked again.

You might want to check our resellers for their stock levels if you want a particular item that is out of stock in our webshop. Here is the link: Country list – Where to buy

Team MakerBeam

OpenBeam clear anodised will be discontinued

We will discontinue the clear anodised OpenBeam range. Clear anodised OpenBeam has not met up to our expectations in sales. Black is more popular. Also we just introduced MakerBeamXL. A 15mmx15mmx15mm profile as well and we have decided to foucs on MakerBeamXL.

In March we will introduce a clear anodised version of MakerBeamXL so there will be an alternative for customers.

In order to cater to OpenBeam fans we will continue sales of OpenBeam black anodised.

Team MakerBeam